Installation & Assembly

Current instructions at www.jeco-inc.com 1-800-893-3006 Page 2 of 4
To Assemble:
Step 1: Route the pre-assembled water hose on the top bowl (A) to the bottom (B).
Step 2: Carefully attach the pump (C) to the hose, making sure to place the pump in the
center of the bottom (B).
Step 3: Fill the basin (B) with clean water, making sure the pump (C) is fully submerged.
Note: The maximum water level should be approximately 1.2 inches below the top edge of
the basin (B).