User`s guide

3
third line. If a split pair is detected, those pin
positions on the second line will be flashing the
pin numbers detected from the remote and the
specific split condition displayed on the third
line. If there are multiple errors to display on
the third line, the messages are displayed in
sequence until all are displayed. The ID icon
will have a number directly below it indicating
the remote ID number.
The LanRoamerPRO
™
is powered on by
pressing any of the four buttons. The tester will
turn on in the last mode used before turning off.
There are four modes of operation as described
below. In any mode, pressing the MODE
button causes the mode select screen to be
displayed. The TURN OFF message is usually
the first one displayed. Subsequent presses
of the MODE button cycle through the other
modes. Pressing the SEL button causes the
currently displayed mode to be entered.
Test/Pre-test – If a remote is sensed, the
tester reverts to the power off cable test
described above (Test). If there is no remote,
the LanRoamerPRO
™
uses the length and
cable test capability to attempt to measure a
cable for shorts, opens and split pairs (Pre-
test). TEST and the current pair under test
icons being on indicate a test in progress. The
results are displayed as messages on the LCD.
Because a test can take up to about 5 seconds
to complete, the SEL button, which immediately