User`s guide

15
Battery Replacement
When the battery low icon is on, the battery
should be replaced as soon as practical. The
cable testing results will become unreliable
when the battery reaches about 4.5 volts.
To Replace Battery
Remove rubber battery cap by pressing
on bottom edge of the cap with the heel of
the hand until the cap pops off.
Pull battery out of cavity and remove
battery snap.
Connect a new Alkaline 9 volt battery to
battery snaps.
Slide battery into cavity and snap cap in
place.
When installing a new battery, disconnect
any cables connected to the tester. The
length and pre-test modes will be improperly
calibrated if a cable is present.
1)
2)
3)
4)