User`s guide

6
To Test Coax (Requires optional RJ45-to-coax
adapter)
1) Plug the RJ45 to F coax adapters into the
remote and
main units.
2) Attach cable to be tested to F connectors.
3) The tester will power on if it senses the
cable. If not, the cable is open. The coax
adapter is connected to the 1-2 pair and will
be on steady if good, or blink the 1-2 and
short lights if shorted.
To Place Tone on a Cable
1) Press and release the TONE button. The
light immediately above the button will start
flashing.
2) Connect cable to be traced to main unit.
For best signal, do not connect remote. Due
to the shielding effect of twisted pairs, the
strongest signal is obtained by connecting
only one wire in a cable to the tone source.
3) To turn tone off, press the TONE button
a second time. The tone will turn off
automatically after 3 hours.