User`s guide

22
• To change the pair measured,
press the SEL button to cycle
through the pairs available for
that mode – For Network mode:
auto-select, 1-2, 3-6, 4-5, 7-8�
For Telco mode: auto-select, 1-
6, 2-5, 3-4� For Coax mode: Pin
+ Shield (the only option)�
• To change length between feet
and meters, use Setup mode�
Note: After a new battery is installed,
the default length constants are
initialized to 15 pF/foot for Network
cable, 22.5 pF/foot for Coax cable
and 17.5 pF/foot for Telco cable. For
Network cable, most Cat 5, Cat 5e & Cat
6 cables have unit capacitances close
to 15pF/foot – check with your cable
manufacturer for possible variances).
Note: If a selected pair has a fault, the
fault replaces the length reading on the
LCD. In default mode, if the 1-2 pair has
a fault, The TestierPROf automatically
sequences to a pair without a fault.