User`s guide

19
ToTestInstalledCable(ofce jack to
patch panel with remote)
1) Remove the remote unit from the
main unit by sliding the remote
towards the top of the main unit�
2) Attach one end of the supplied one-
foot patch cable to the remote and
other end to the wall jack�
3) Attach one end of the second
supplied one-foot patch cable to the
main unit and the other end to the
patch panel jack�
4) Press the mode button (Telco, Coax,
or Network) for the type of cable
being tested� If not already in Cable
Test mode, press the corresponding
mode button repeatedly until Cable
Test is displayed and then press
the SEL button to execute cable
test. The TestierPROf indicates
a test in progress by displaying the
TEST icon� If the cable passes the
set shield criteria and the T568A/B
standard, the TestierPROf displays
within 2 seconds a wire map and
a PASS icon and sounds a beep
(if enabled)� The ID number for the
remote will also be displayed�
5) Disconnect the cable after test� The
test repeats itself every 5 seconds�
Application Hint: The jumper cables
must be short compared to the cable run