User`s guide

12
CAT 5/6 cable), the error message “>
Max Length” will be displayed�
Tone – The tone mode generates audio
tones for use with tone tracers on all
pairs, a selected pair or a selected pin�
The signal generated on a pair has the
signal on one pin and the complement
of the signal on the other pin of the pair,
yielding a nominal 10 volts peak-to-peak
across the pair� The pin(s) being driven
with tone and the currently selected
tone pattern are displayed on the screen
along with the “Tone” icon and the icon
for the connector assumed to be used�
Once in the tone generator mode, use
the up and down buttons to step to
the next connector pin(s) drive option�
When the SEL button is pressed and
held down for longer than 1 second, the
tone pattern options are automatically
cycled through until the button is
released� The tone pattern options are
Hi, Lo, Tone 1 and Tone 2� The last
two options are dual or warble tones of
differing pattern duration� Press any
mode buttons or the Power button to exit
Tone mode�
Hub Blink – Hub blink mode sends link
pulses to the network switch to blink
the port LED and identify the port the
Network cable connected to� The Hub