User`s guide

10
type of map-only remote is used (e�g�
a Coax remote used in Telco mode), a
message with the remote type identied
will be displayed� If a full-remote instead
of a map-only remote is used, an error
message will be displayed� If no remote
is found, or if the cable is shorted, the
OPEN or SHORT icons will be displayed
respectively�
Length – Length mode measures
the length of a cable by measuring
its capacitance and using the user-
adjustable capacitance per unit length
(the length constant) to calculate
the cable length. The TestierPROf
supports three user-adjustable length
constants - one for each type of
cables. The TestierPROf remembers
these constants even when the unit is
powered off as long as a good battery
is connected to the unit� In Network
mode, cross-over cables are recognized
by displaying the PASS icon and the
“X-OVER” message after the length. In
Telco mode, reverse-pinned cables are
recognized and a “REV-PIN’D” message
added after the measured length value�
The PASS icon is displayed if it is a
correctly wired reverse-pinned 6-position
cable�