User`s guide

7
in that position and a message of
“High-R Fault” displayed on the third
line�
• If a split pair is detected,
corresponding pin positions on the
second line will display ashing pin
numbers detected from the remote�
The specic split conditions are
displayed on the third line�
• If there are multiple errors to display
on the third line, messages for the
highest severity errors are displayed
in sequence until all are displayed�
So if there are both shorts and
high-R Faults, only messages for
the shorts are cycled through� The
ID icon will have a number directly
below it indicating the remote ID
number�
If there is no remote, the TestierPROf
uses the length and cable test capability
to attempt to measure a cable for shorts,
opens and split pairs (Pretest�) While
the test is in progress the test icon and
the wire numbers for the pair being test
are displayed. The nal test results are
displayed as messages on the LCD�
Because a test can take up to about 5
seconds to complete, the SEL button,
which immediately starts a new test,
should be pressed whenever a new