User`s guide

Chapter 4 Performing Cabling Tests
Performing Remote Mapping Tests
LanScaperPRO Network Tester User’s Guide 45
Performing Remote Mapping Tests
The Remote Mapping test finds and displays the number
of the remote identifier (wiremapper) attached to the end
of the cable under test. This test assumes that a one-of-
twenty remote identifier is connected at the terminal end
of each cable to be mapped. Twenty piece sets of remote
identifers are available from JDSU as separately order-
able accessories. (See “Accesories” on page 6.)
To peform remote mapping tests
1 Place a remote identifer at the terminal end of each
cable to be mapped. (Multiple cables can be mapped
in one operation by first attaching one remote identi-
fier to the terminal end of each cable and then testing
each cable one-at-a-time at the central location to
identify the unique ID of each attached identifier.)
2 At the central location (equipment closet) where the
cables to be mapped come together, connect the
cable to be mapped to the connector on the
LanScaperPRO.
3 Access the Cable Test Menu. (See “Accessing the
Cable Test Menu” on page 41.)
4 Scroll through the menu options using the arrow keys
until Remote Mapping is highlighted.
5 Press the SEL key.
The pre-test Mapping Test Results screen appears
with two areas showing at the top: the cable pairs
status area on the left and the wiremap area on the
right. (See Figure 19 on page 46.)
LanScaperPRO_User_Guide.book Page 45 Friday, January 25, 2008 1:14 PM