User`s guide

Chapter 3 Performing Network Tests
Performing Ping Tests
28 LanScaperPRO Network Tester User’s Guide
the four decimal numbers separated by periods
represents one hexadecimal byte of the four byte
IP address and can only have values from 0-255.
In addition, each digit in the decimal number can
only be set to a value valid for that position, as in,
the high order digit in any of the decimal
numbers can only be set to 0,1, or 2. Each digit
can also only be set to a valid value in relation to
the low-order digits in that number. For example,
the high order digit can only be set to 2 if the low
order digits are less than 55. The desired IP
address may have to be entered from right to left
to allow the low order digits to be set prior to the
high order digit. Any IP address can be entered
for a target, either on or off the LAN segment,
even “reserved” IP addresses.
d When complete, press ACCPT to save the new
target IP address value or press QUIT to revert
to the to the previous target IP address.
9 If DHCP OFF mode was selected, an IP address must
be manually entered for MyIP (the IP address for the
LanScaperPRO). To enter or modify this address,
complete the following steps:
a Highlight the IP address to the right of the MyIP
field using the arrow keys.
b Press the SEL key.
The Edit My IP screen appears. (See Figure 10
on page 29.)
LanScaperPRO_User_Guide.book Page 28 Friday, January 25, 2008 1:14 PM