User`s guide

Chapter 3 Performing Network Tests
Performing Ping Tests
LanScaperPRO Network Tester User’s Guide 25
are reported. (Note that the duplex mode of the
remote device cannot be detected without Auto-
Negotiation.)
If no active Ethernet devices are found, the LanScap-
erPRO checks the cable for the typical signatures of
inactive Ethernet, Token ring, or ISDN devices. If
found, the LanScaperPRO will report what it detects.
If none of the above is found, the LanScaperPRO
invokes a Cable Test and displays the results. (See
“Performing Cable Tests” on page 41.)
To exit Port Discovery mode, press the QUIT key.
Performing Ping Tests
The Ping test is used to request an echo back from an
addressed device (target) and verify IP connectivity
between the LanScaperPRO and another device.
To perform a Ping test
1 If the jack or plug is unknown, run a Port Discovery
test to verify that an active Ethernet port is
connected. (See “Performing Port Discovery Tests”
on page 23.)
2 Connect the LanScaperPRO to the network.
3 Access the Network Test Menu. (See “Accessing the
Network Test Menu” on page 22.)
4 Scroll through the menu options using the arrow keys
until Ping Test is highlighted.
5 Press the SEL key.
LanScaperPRO_User_Guide.book Page 25 Friday, January 25, 2008 1:14 PM