User`s guide

Chapter 2 Operation
Installing or Replacing the Batteries
LanScaperPRO Network Tester User’s Guide 13
Installing or Replacing the Batteries
To run the LanScaperPRO Network Tester, four new Alka-
line or charged NiMH AA batteries must be installed in the
battery compartment. (Note that batteries are not included
with the unit; you must supply your own.) Use the proce-
dure below to install or replace the batteries.
To install or replace the batteries
1 Disconnect the tester from any external connection
before opening it to install or replace the batteries.
2 Using a screwdriver, remove the two screws holding
the battery compartment cover. Remove the cover.
3 If replacing old batteries, pull them out of the battery
compartment and dispose of them according to local
regulations.
4 Insert four new Alkaline or charged NiMH AA
batteries.
5 Replace the cover and screws.
NOTE
After batteries are installed in the unit, if the LOW BATT
indicator light comes on, the batteries should be
replaced as soon as is practical. If the LOW BATT indi-
cator is on and the unit is not, the batteries must be
replaced to continue using the unit.
LanScaperPRO_User_Guide.book Page 13 Friday, January 25, 2008 1:14 PM