User`s guide

5
Press left or right arrows to move curser ( ) next to a device
acronym. Press SEL button to view more information about a device.
There are a total of three screens to view. Press SEL button to
advance to the next screen or the screen will advance automatically
after 10 seconds.
2.7 To Validate a Cable Link by Functional Testing
Two LanScaper™ testers can be used to exercise a cable link with no
additional equipment being required. This can also be done through a
HUB or switch with or without any other equipment being present. The
two LanScapers™ will be referred to as the Validator and the PING
Generator. The Validator uses the Validate Link mode and the PING
Generator uses PING Test mode.
Connect the Validator to one end of the link to be tested.
Press NTWRK button until Validate Link is displayed. Press SEL
button to activate test.
In SETUP, set PING Generator to DHCP Off (see To Change PING
Addressing, below). A specic manual address does not need to
be set, the PING Generator will recognize the Validator and assign
addressing.
Connect the PING Generator to the other end of the link.
On the PING Generator, press NTWRK button until PING Test is
displayed and press SEL button to begin.
The target or router acronym will change to Val on the PING
Generator when the Validator is found and addressing assigned. The
PING Generator operates and accumulates information as in the
normal PING Test. The Validator displays a packet count only on its
screen.
2.8 To Change PING Addressing Mode
Other options are changed similarly.
Turn on LanScaper™ by pressing PWR button and press the middle
of the CABLE/NTWRK button, which is marked SETUP. The percent
battery remaining screen will appear briey.
Press down arrow button three times, DHCP On or DHCP Off should
be displayed.
Press SEL button to toggle between on and off. Displayed value is
current setting.
Press CABLE or NTWRK to exit to a test or press and hold PWR
button to power off.
3)
1)
2)
3)
4)
5)
6)
1)
2)
3)
4)