O P E R AT I N G I N S T R U C T I O N S | D I G I TA L-T O - A N A L O G C O N V E R T E R E L D A C I I+ SUPPORT ONLINE BY PHONE BY MAIL C O N TA C T @ J D S L A B S . C O M 314-252-0936 909 N BLUFF RD JDSLABS.
SECTION 1 SECTION 2 QUICK SETUP C O N F I G U R AT I O N Connectivity EL DAC II accepts three methods of digital input: STEP 01 Connect AC power adapter to rear power jack, then connect to wall outlet STEP 02 Connect cables to your desired digital audio players: USB, TOSLINK, or coaxial USB 16/44.1k thru 32/384kHz** Coaxial S/PDIF 16/8kHz thru 24/192kHz* TOSLINK 16/8kHz thru 24/192kHz* Maximum RCA Output voltage is 2.
Listening Tips For maximum signal fidelity, set the DAC to at least 24-bit audio and adjust digital volume slightly below 100% at your computer. Only control volume from your amplifier. Listen safely to conserve your hearing: www.hearingloss.org To ensure an optimal noise floor, always position audio equipment as far away as possible from wireless devices. SECTION 3 SETUP Set sampling rate to the highest integer multiple of your music collection. For example, use 176.4kHz for a collection of 44.
Troubleshooting FCC Requirement No USB device or “Failed to Play Audio” Cause: USB Device is not initialized. Solution: Tap mode button 3x to cycle through all modes and reset the USB device. No sound in one channel Cause: Bad cable, or incorrect computer settings. Solution: Check balance settings; try another headphone or RCA cable. Some Mac OS X systems will pan audio to the Left channel upon initial connection of a DAC. User must restore balance to center.
