Installation Instructions

COD. 1248034-GB / 1.1

RBAND/OS – RBAND/OSB

- 6 -

• PROGRAMMATION

Each safety edge transmitter must be learnt into the appropriate channel of the safety edge receiver.

Mode Configuration of transmitter programming in the receiver. Led R1 Led R2

1 By pressing the transmitter, relay 1 on the receiver will be activated

ON OFF

2 By pressing the transmitter, relay 2 on the receiver will be activated OFF ON

3 By pressing the transmitter, the two relays will be activated at the same time ON ON

4 The relays are activated 1st relay by channel 1 (operate as normal operation for connecting a

safety element) and 2nd relay by channel 2 (connection of an auxiliary input, the sender

transmits the status of the auxiliary input to the second relay of the receiver) (operates as a

normally open contact for connecting an auxiliary input)

Flashing

Notes:

- Modes 1, 2 and 3: Up to 6 transmitters (3 on output R1 and 3 on output R2) can be connected to the receiver in modes

1, 2 and 3.

- Mode 4: In this mode only 3 transmitters can be connected to the receiver. The second relay cannot make the function

of indicating low battery.

- Each transmitter can be configured independently on the receiver.

- A Transmitter should only be connected to one receiver.