User's Manual

www.milleredge.com [e-mail] 800-220-3343
IMAGE 3. RBand Edge Transmitter PCB & Connections
3. TRANSMITTER: PROGRAM MODE
3-1. Confirm the Receiver is powered up. Prior to mounting the Transmitter, remove the cover and insert the
batteries, noting their polarity. The green LED on the Transmitter should blink to indicate that it has not been
associated with the Receiver yet [IMAGE 3].
3-2. To enter learn mode, press and hold the Receiver program button for ~2 seconds until the R1 LED turns
on, then release the button [IMAGE 2].
3-3. Press the Transmitter program button for ~2 seconds [IMAGE 3]. The Receiver should beep. Wait 10
seconds for an additional beep to indicate that programming is complete.
3-4. To program a Transmitter to Channel 2, press and hold the Receiver program button until the second beep,
then release the button. The R2 LED should be on [IMAGE 2]. Repeat 3-3.
4. TRANSMITTER: INSTALL & TEST
4-1. Strip back approximately 2 inches of outer covering of sensing edge cable, then feed through Transmitter
strain relief fitting. Connect the two sensing edge wires to the removable terminal. Dress the wires with a
small service loop and tighten the strain relief. Mount unit utilizing the mounting holes at the 4 corners of the
Transmitter box. Affix lid to Transmitter, noting the alignment pin [IMAGE 3].
4-2. Test the sensing edge for functionality.
5. TROUBLESHOOTING
If the Receiver does not react to the Transmitter, you can check the RF signal strength:
5-1. Press the check button on the Receiver for ~2 seconds [IMAGE 2]; 4 beeps will be heard. You then will hear
a beep every 1-1/2 seconds during the check process. Wait about 30 seconds; if no other beeps occur, your
system is functioning. 3 quick beeps indicates a communication error.
5-2. Activate the sensing edge and observe the check LED; 3-5 flashes is ideal. Less than 3 flashes means
there is a weak signal.
5-3. To exit check function, press the check button, or system will time-out after 5 minutes. There will be a
series of beeps heard upon exiting.
6. ERASING THE RECEIVER
If you need to replace a Transmitter or you have any other programming issues, you may need to erase the
Receiver.
6-1. To erase any Transmitters programmed into the Receiver, use a screwdriver to short the two pins marked
MR next to the DIP switches [IMAGE 2].
6-2. While shorting the pins, press and hold the program button for several seconds; you will hear a series of 10
beeps followed by a rapid chirping sound.
6-3. When the chirping stops, release the program button. Wait ~10 seconds and you will hear 2 beeps. The
Receiver is now ready to be reprogrammed.
PROGRAM BUTTON
REMOVABLE
SENSING EDGE
TERMINAL BLOCK
(4) CORNER
MOUNTING HOLES
GREEN LED
ALIGNMENT PIN
STRAIN RELIEF FITTING
ALIGNMENT PIN
(2) 3.6V AA LITHIUM
BATTERIES