User's Manual

COD. 1248017-GB / 1.2

BASE500

Self-programming

After the receiver has been totally reset, it will be configured with the group of the first

radio-programmed transmitter by enabling the hands free mode.

Exception: If the receiver has been configured using programming tools, the group may

only be changed with the programming tool.

Operations

On powering the receiver, the led R1 will flash the same number of times as the group

number with which it is configured.

USE OF THE RECEIVER

These receivers are designed for use as remote controls for garage doors. Their use is not

guaranteed for directly activating any other equipment different to that specified.

The manufacturer reserves the right to modify equipment specifications without prior

notice.

IMPORTANT ANNEX

Disconnect the power supply before handing the unit.

In compliance with the European Directive low-voltage electrical equipment, we hereby

inform users of the following requirements:

· For units which are permanently connected, an easily accessible circuit-breaker device

must be built into the wiring system.

· This unit must always be installed in a vertical position and firmly fixed to the structure of

the building.

· This unit must only be handled by a specialised installer, by his maintenance staff or by a

duly trained operator.

· The instruction manual for this unit must always remain in the possession of the user.

· Terminals of maximum section 3,8mm2 must be used for the power supply connections.

· Use time delayed fuses.

Hereby, JCM TECHNOLOGIES, S.A., declares that this BASE500-1B, BASE500-

2B is in compliance with the essential requirements and other relevant provisions

of Directive 1999/5/EC.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following

two conditions: (1) this device may not cause harmful interference, and (2) this device

must accept any interference received, including interference that may cause undesired

operation.

To comply with FCC rules, adjustment or modifications of this receiver and/or transmitter

are prohibited, except for changing the code setting or replacing the battery. THERE ARE

NO OTHER USER SERVICEABLE PARTS. Any other changes made, not expressly

approved by JCM Technologies, S A could void the user’s authority to operate the

equipment.

CE DECLARATION OF CONFORMITY

See web www.jcm-tech.com