User's Guide

ASSISTANT FCC
4
3.2 INSTALLATION DE LES DRIVERS
Insérez le clé USB dans le lecteur du PC correspondant. Reliez le câble USB au programmateur au PC. Une fenêtre
s’ouvrira avec un message indiquant la localisation d’un nouveau matériel. L’assistant de Windows correspondant s’auto-
exécutera alors. Suivez les instructions qui s’afficheront à l’écran. Durant l’installation du matériel, l’assistant vous
demandera de sélectionner la route du pilote USB : vous devez sélectionner le lecteur de USB.
3.3 EXÉCUTION
À l’exécution de l’application, le programme demandera un nom d’utilisateur et un mot de passe. Le nom d’utilisateur par
défaut est « softadmin » et le mot de passe « assistant ».
Utilisateur: softadmin
Mot de passe: assistant
EMPLOI DU PROGRAMMATEUR
Pour information, consultez l’aide du programme Soft-ASSISTANT.
Le fabricant se réserve le droit de modifier les caractéristiques du matériel sans préavis.
CONFORMITÉ ISED / FCC
Modèle: ASSISTANT FCC
FCC ID: U5Z-ASSISTANT
IC: 8572A-ASSISTANT
JCM Technologies has not approved any changes or modifications to this device by the user. Any changes or modifications
could void the user’s authority to operate the equipment.
JCM Technologies S.A. n’approuve aucune modification apportée à l’appareil par l’utilisateur, quelle qu’en soit la nature.
Tout changement ou modification peuvent annuler le droit d’utilisation de l’appareil par l’utilisateur.
This device complies with Part 15 of the FCC Rules and Industry Canada’s licence-exempt RSS standards. Operation is
subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any
interference, including interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence.
L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2)
l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en
compromettre le fonctionnement.
FCC Class B digital device notice
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
UM_3200903_ASSISTANT FCC_Rev01