OPERATOR'S MANUAL MAINTENANCE

Section 1 - General Information
1-15 1-15
9803-9880-3
Service Tools
Numerical List
The tools listed in the table are special tools required for
carrying out the procedures described in this manual.
These tools are available from JCB Service.
Some tools are available as kits or sets, the part numbers
for parts within such kits or sets are not listed here. For full
details of all tools, including the content of kits and sets,
refer to Tool Detail Reference, Section 1.
Note: Tools other than those listed will be required. It is
expected that such general tools will be available in any
well equipped workshop or be available locally from any
good tool supplier.
Part
Number
Description See Section
993/68100 Slide Hammer Kit - see Tool Detail Reference (Section 1) for content B
- Rivet Nut Tool - see Tool Detail Reference (Section 1) B
892/00842 Glass Lifter B
892/00843 Folding Stand for Holding Glass B
892/00845 Cartridge Gun B
892/00846 Glass Extractor (Handles) B
892/00847 Nylon Spatula B
892/00848 Wire Starter B
892/00849 Braided Cutting Wire B
926/15500 Rubber Spacer Blocks B
992/12300 12V Mobile Oven B
992/12400 240V Static Oven (2 Cartridge) B
992/12800 Cut-Out Knife B
992/12801 'L' Blades B
4104/1310 Hand Cleaner B
892/00281 AVO Meter (not illustrated) C
892/00298 Fluke Meter C
892/00285 Hyd. Oil Temperature Probe C
892/00284 Digital Tachometer C
892/01174 DLA Kit C
331/22966 Pump Drive Alignment Tool (not illustrated) E
- Male Adapters - BSP x BSP - see Tool Detail Reference (Section 1) E
- Male Adapters - BSP x NPT (USA only) - see Tool Detail Reference (Section 1) E
- Pressure Test Points - Adaptors - see Tool Detail Reference (Section 1) E
- Pressure Test Points - 'T' Adaptors - see Tool Detail Reference (Section 1) E
- 'T' Adaptors - see Tool Detail Reference (Section 1) E