OPERATOR'S MANUAL MAINTENANCE

Section 3 - Maintenance
Routine Maintenance
Engine
3-72 3-72
9803/JSM-0412
Engine Air Filter
Changing the Outer Air Filter Element
!MCAUTION
The outer element must be renewed immediately if the
warning light on the instrument panel illuminates.
2-3-3-1
Note: Do not attempt to wash or clean the elements - they
must only be renewed.
Note: Do not run the engine with the dust valve F
removed.
Note: Change the outer element more frequently if
operating in dusty conditions. A new inner element must
be fitted at least every other time the outer element is
changed. As a reminder, mark the inner element with a pen
each time the outer element is changed.
1 Stop the engine.
2 Press clips A and lift off cover B. Remove outer
element C. Take care not to tap or knock the element.
3 Clean the inside of cover B and canister D.
4 Insert a new element into the canister, check seal E is
fully seated. Fit cover B with dust valve F at the
bottom. Push the cover firmly into position and make
sure it is secured by clips A.
5 Make sure that the wire is connected to the Air Filter
Blocked switch.
6 Check all hoses for condition and tightness.
Fig 47.