OPERATOR'S MANUAL MAINTENANCE

Section 3 - Maintenance
Routine Maintenance
To o ls
3-28 3-28
9803/JSM-0412
Tools
Carrying Tools onto the Machine
When you carry tools onto the machine you must maintain
three points of contact with the machine at all times. Lift
tools onto the machine in intervals if necessary. Place the
tools down before you adjust your grips on the machine.
Do not try to adjust your grips on the machine while holding
tools.
Locations
The machine is equipped with a a grease gun (option) and
remote oil-drain tube attachment.
The grease gun is stowed into position with clips A,
K Fig 2. ( T 3-28).
The drain tube is stowed into position by its screw thread
B,
K Fig 3. ( T 3-28).
Keep the tools in their stowage positions until they are
needed. The location of the tools will vary dependant on
the machine variant:
JS115-JS290
The grease gun is stowed in the toolbox. The toolbox can
be locked with the key.
The drain tube is stowed in the service bay behind the cab,
next to the engine air filter. The service bay can be locked
with the key.
JS330/JS360
The grease gun is stowed in the service bay behind the
cab. The service bay can be locked with the key.
The drain tube is stowed in the radiator bay. The radiator
bay can be locked with the key.
Fig 2.
Fig 3.
A
B