OPERATOR'S MANUAL MAINTENANCE

Section E - Hydraulics
E-215 E-215
9803/9880-3
Service Procedures
Make the Machine Safe
TE-009
Note: You can complete most of the maintenance
procedures with the boom lowered. Unless a maintenance
procedure instructs you differently, you must lower the
boom.
You must make the machine safe before you complete any
service procedures.
1 Park the machine on firm level ground.
2 Apply the parking brake (if fitted).
3 Lower the equipment or, raise and fit the applicable
safety strut.
4 Stop the engine.
5 Turn the ignition to the `ON' position.
6 Operate the hand controllers to release pressure in
the hydraulic system.
7 Turn the ignition to the `OFF' position.
8 Remove the starter key
9 Disconnect the battery (if necessary).
10 Release the hydraulic oil tank pressure.
11 Chock the wheels/tracks as applicable.
12 If the machine is raised from the ground make sure it
is securely chocked. NEVER WORK UNDER A
MACHINE RAISED ON STABILISERS OR JACKS.
13 If you wish to arc weld the machine disconnect the
alternator and electronic control units (if fitted).