OPERATOR'S MANUAL MAINTENANCE

Section E - Hydraulics
Hydraulic Rams
Removal and Replacement
E-183 E-183
9803/9880-3
Removal and Replacement
Typical Bucket Ram
P11-E001_2
Removal
!MWARNING
Hydraulic Pressure
Hydraulic fluid at system pressure can injure you.
Before connecting or removing any hydraulic hose,
residual hydraulic pressure trapped in the service
hose line must be vented. Make sure the hose service
line has been vented before connecting or removing
hoses. Make sure the engine cannot be started while
the hoses are open.
INT-3-1-11_2
!MWARNING
Lifting Equipment
You can be injured if you use faulty lifting equipment.
Make sure that lifting equipment is in good condition.
Make sure that lifting tackle complies with all local
regulations and is suitable for the job. Make sure that
lifting equipment is strong enough for the job.
INT-1-3-7
1 Lower the attachment to the ground.
709670
Fig 1.
2 Place a wooden block under the bucket ram.
803090
Fig 2.
3 Stop the engine, remove the key.
Release the tank pressure, see Releasing the Tank
Pressure.
709600
Fig 3.
4 Remove the nuts and bolts from the rod end of the
ram.