OPERATOR'S MANUAL MAINTENANCE

Section C - Electrics
Service Procedure
Using a Multimeter
C-167 C-167
9803/9880-3
Using a Multimeter
TC-002
In order to obtain maximum benefit from the fault finding
information contained in Section C it is important that the
technician fully understands the approach to fault finding
and the use of the recommended test equipment, in this
case a FLUKE 85 or AVO 2003 digital multimeter, or a
moving pointer (analogue) multimeter. The approach is
based on a fault finding check list. In tracing the fault from
the symptoms displayed you will be directed to make
measurements using a multimeter.
These instructions are intended to cover the use of the
recommended multimeters.
Fig 7. FLUKE 85
Fig 8. AVO 2003
Fig 9. A Typical Analogue Meter
1 Make sure that the test leads are plugged into the
correct sockets. The black test lead should be