JBL STUDIO MONITOR MODEL 4365 ® 3-way loudspeaker 4365 4365 OWNER’S MANUAL 0219CSK - JBL Studio Monitor Model 4365 OM v1.
INTRODUCTION THANK YOU for purchasing the JBL® studio monitor model 4365. The 4365 is a new member of the family of JBL large studio-monitor speakers that dates back to 1963 with the original model 4320 studio monitor. By incorporating technology first developed for the Project K2S9900 with new Bi-Radial® horns, the 4365 fuses innovation with JBL tradition. To get the best performance from your new studio monitor, please read these instructions thoroughly.
English Changing the Speaker’s Feet The 4365 is shipped with rounded feet attached to the bottom of its cabinet. TO CHANGE TO THE INCLUDED SPIKED INSERTS: 1. Turn the speaker upside down onto a thickly carpeted or well-padded surface. 2. Unscrew and remove the rounded inserts of the installed feet. If the inserts are difficult to loosen, use an 18mm (11/16-inch) wrench. 3. Screw the spiked inserts into the feet. A. Remove Rounded Foot Insert B.
CONNECTIONS CAUTION: Make sure that all of the system’s electrical components are turned OFF (and preferably unplugged from their AC outlets) before making any connections. Speakers and amplifiers have corresponding positive and negative (“+” and “–”) connection terminals. The 4365 has two sets of connection terminals; jumper wires connect the terminals to each other. The terminals are marked “+” and “–”. Additionally, the “+” terminals have red rings, while the “–” terminals have black rings.
English Using Spade Connectors: A. Unscrew Cap B. Insert Spade Connector Blades around Post C. Tighten Cap IMPORTANT: Make sure the (+) and (–) spade connector blades do not touch each other or the other terminal. Touching blades can cause a short circuit that can damage your receiver or amplifier. Using Banana Connectors: A. Tighten Cap B. Insert Banana Connector into Hole in Cap BI-WIRE CONNECTION: The 4365 connection assembly has two sets of input terminals that are connected by jumper wires.
BI-WIRE CONNECTION (continued): If you’re bi-wiring with two stereo power amplifiers, connect the speakers according to the following illustration. Left Speaker Right Speaker Amplifier 1 Left Ch. Right Ch. Mid/Tweeter Connection Woofer Connection Left Ch. Right Ch. Amplifier 2 Woofer Connection Mid/Tweeter Connection In either case, follow the instructions for the different connector types in Basic Single-Wire Connection, on page 4.
English SPECIFICATIONS JBL® studio monitor model 4365 Low-frequency transducer: 380mm (15") cone driver with Vented Gap Cooling™, a 100mm (4") voice coil and a three-layer sandwich cone (model 1501FE) High-frequency transducer: 100mm (4") compression driver with magnesium-alloy diaphragm and 38mm (1-1/2") exit (model 476Mg) Ultrahigh-frequency transducer: 25mm (1") compression driver with pure titanium diaphragm (model 045Ti-1) Recommended amplifier power: 50W – 300W Frequency response: 35Hz – 40k
Harman Consumer, Inc. 8500 Balboa Blvd., Northridge, CA 91329 USA www.jbl.com © 2010 Harman International Industries, Incorporated. All rights reserved. JBL and Bi-Radial are trademarks of Harman International Industries, Incorporated, registered in the United States and/or other countries. Vented Gap Cooling is a trademark of Harman International Industries, Incorporated. Features, specifications and appearance are subject to change without notice. Part No.
