Owner`s manual

8
TROUBLESHOOTING YOUR JBL JBL ON STAGE MICRO III
PROBLEM SOLUTION
No sound (white LED is not illuminated): •MakesurethatthepowersupplyisproperlyconnectedtotheJBLOnStageMicroIII
and to a working AC outlet.
•Ifyou’reusingbatterypower,replaceallfourbatterieswithbrand-newdisposableor
freshly charged rechargeable batteries. The LED will illuminate amber if the batteries
need replacing.
•JBLOnStageMicroIIIisintheenergyconservationmode(nosoundwasdetected
for at least 10 minutes).
No sound (white LED is illuminated): •TouchtheVolumeUp(+)buttontoincreasethesystemvolume.
•Ifyou’reusingadockediPod/iPhone,makesurethatitisproperlydockedintheJBL
On Stage Micro III.
•Ifyou’reusinganauxiliarysource,makesurethattheaudiocableisproperly
connected to the JBL On Stage Micro III’s Audio In connector and to the source
component’s audio output.
•MakesurethattheiPodorsourcecomponentisnotinthePausemode,andthatits
volume control is not turned all the way down.
Sound crackles, hisses or is distorted: •TurntheiPodorsourcecomponent’svolumedown.
•MakesuretheiPod’sEQsettingissetto“Off.”
Loud hum or buzzing: •MakesuretheaudiocableispluggedallthewayintotheAudioInputjack.
•Replacetheaudiocable.
•UnplugthepowersupplyandconnectittoadifferentACoutlet.
TROUBLESHOOTING YOUR JBL ON STAGE MICRO III