Owner's Manual

D
Stadium 10
--
9 \!:'.16'. 1235 §rm>!.
SPEAKER SIGNAL WIRING
To send signal to the JBL manne speaker, connect the positive(+) and negative(-) speaker wires to the appropriate speaker
outputs of your source unit or amplifier. Be sure to observe proper polarity.
0
+RGB
SPEAKER LED WIRING
To provide power for the LEDs, plug the 24-gauge black(+), blue, green, and red LED wires from the speaker into the
included female connector, then run the wires from the female connector to your compatible 12-volt power source or light
controller (sold separately) . If using a separate controller, be sure to connect each wire to the proper output.
Blue
Green
Red
Black
To speaker -
- t::Jt:::==============
If hardwiring the LEDs directly to your power source, you can choose the color of the LEDs by connecting the black wire to
the positive (+) terminal, and the appropriate R, G, and /or B single wire or combination of wires to the negative (-) terminal.
There are 7 possible colors, depending on the wiring configuration you choose: