JBLP2706_ES150-250PW-120om 5/20/08 4:15 PM Page 1 ® ES SERIES ES150PW, ES250PW (120V) OWNER’S GUIDE
JBLP2706_ES150-250PW-120om 5/20/08 4:15 PM Page 2 IMPORTANT SAFETY PRECAUTIONS Read First! 1. Read these instructions. 2. Keep these instructions. 3. Heed all warnings. 4. Follow all instructions. 5. Do not use this apparatus near water. 6. Clean only with a dry cloth. 7. Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions. 8.
JBLP2706_ES150-250PW-120om 5/20/08 4:15 PM Page 3 INTRODUCTION PLACEMENT ES150PW/ES250PW Wireless Powered Subwoofers Since the installation of a subwoofer can be somewhat more complicated than installing full-range speakers, it is essential that you read this section very carefully prior to connecting the subwoofer to your system. Should you have questions relating to your installation, it is advisable to contact either your dealer or the JBL Customer Service Department for advice.
JBLP2706_ES150-250PW-120om 5/20/08 4:15 PM Page 4 CONTROLS AND CONNECTIONS Rear Panel ¡ Power Switch ™ Line-Level Inputs £ LFE Input ¢ Low-Pass Selector (Wireless Input Only) ∞ ID-Code Selector Phase Antenna § Crossover Adjustment Control • ª ¶ Subwoofer-Level (Volume) Control Level • Phase Switch ¶ ª Wireless Antenna Crossover [Hz] ∞ § Transmitter ‚ Transmitter Antenna Wireless ⁄ Transmitter Power-Supply Input Off ID Code On B Transmitter ID-Code Selector Low-Pass ¢ ™ £ R L ‹
JBLP2706_ES150-250PW-120om 5/20/08 4:15 PM Page 5 SYSTEM CONNECTIONS Choose either Wireless or Wired connection, then follow the appropriate instructions. WIRELESS WIRED Connecting the Subwoofer for Wireless Applications Connecting the Subwoofer for Wired Applications If you have a Dolby® Digital or DTS® receiver/processor with a low-frequency effects (LFE) or subwoofer output: Level Crossover [Hz] ID CODE DC18V 1 2 3 4 Sub In 1.
JBLP2706_ES150-250PW-120om 5/20/08 4:15 PM Page 6 OPERATION Power On Connect your signal source (such as an A/V receiver or preamplifier) to the transmitter (if using a wireless connection) or to the subwoofer (if using a wired connection). Two single-RCA cords are provided. While you would ordinarily use the short cable to connect to the transmitter or the long one to connect to the subwoofer, either cable can be used, depending on proximity to the signal source.
JBLP2706_ES150-250PW-120om 5/20/08 4:15 PM Page 7 MAINTENANCE AND SERVICE The enclosure may be cleaned using a soft cloth to remove fingerprints or to wipe off dust. The grille may be gently vacuumed. Stains may be removed with an aerosol cleaner, following its instructions. Do not use any solvents on the grille. All wiring connections should be inspected and cleaned or remade periodically.
JBLP2706_ES150-250PW-120om 5/20/08 4:15 PM Page 8 Features, specifications and appearance are subject to change without notice. JBL is a trademark of Harman International Industries, Incorporated, registered in the United States and/or other countries. Elliptical Oblate Spheroidal, PolyPlas and Pro Sound Comes Home are trademarks of Harman International Industries, Incorporated. Dolby is a registered trademark of Dolby Laboratories. DTS is a registered trademark of DTS, Inc.
