Owner's Manual

Buttons and Functions

1. The BACK button will back you out of the current screen you are in without saving changes. This can be thought

of as a “CANCEL” button.

2. Holding the back button for 2s will engage Mix Mode

Mix Mode

1. Press and Hold the BACK button for 2s to engage Mix Mode

a. All LEDs will turn ON, indicating you’ve successfully initiated Mix Mode

2. In mix mode, the knobs will now control their respective channel gains. For example, twisting the knob

labeled CH1 will increase the gain of CH1.

3. EON ONE MK2 has an automatic mic/line switch. Between-100dB and 0dB, the channel will be in LINE mode.

Between 1dB and 56dB, the channel will be in MIC mode.

Channel Strip Mode

1. Access Channel Strip mode by

a. Press the rotary knob of the channel you wish to edit.

2. When in Channel strip mode, the knobs control the respective listed function of the selected channel (i.e. Gain,

Bass, Mid, Treble, Reverb Send, Delay Send, Chorus Send)

LEDs and Functions

1. Signal detection - LED below channel knobs will periodically flash yellow to indicate signal is present.

2. LED function when Muting Channels/Speaker : LED Below Channel knobs will slowly ash RED when a channel

is muted.

SSM

Signal Level for LED Metering Mix Mode Channel Strip Mode

Clipping Channel LED Bright Red Selected Channel LED Bright Red

Strong signal Channel LED Bright Yellow Selected Channel LED Bright Yellow

Weak signal Channel LED Bright Green Selected Channel LED Bright Green

No/Low Signal All LED Dim Green "Selected Channel LED Dim Green"

Mute

Muted channel LEDs ashes

Dim Red

"Selected Channel LED ashes

Dim Red"