connection guide

II. Speaker Back Panel Controls
The speaker has several DSP features accessible from the speaker:
EQ Preset Select: Use this button to toggle through four different built in EQ
Presets- MAIN, MONITOR, SUB, SPEECH.
EQ+ Enable: Enables the EQ+ settings assigned in the app; pressing the EQ+
button on the speaker for about 3 seconds will cause the current state to toggle.
This EQ helps the user to further customize a secondary EQ with the App and store
the preset on a device or load a preset from a device.
Bluetooth Sync: The Sync button will make the speaker discoverable for the mobile
application.
Bluetooth Boot: Takes the speaker out of discoverable mode. If connected to the
application, the boot button does not work until the mobile application disconnects
from the speaker.
Firmware Update Completion: When updating the firmware of the speaker from the
App is complete, the power and Bluetooth LED will blink. If they blink in unison, the
update was successful.
Factory Reset: While powering up the speaker, holding EQ+ and Boot buttons will
return the speaker to factory default settings. When the reset begins all LEDs will
blink on the speaker control panel.
III. First-Time Setup
1. Install the EON Connect app from Google Play Store.
2. Factory reset the speaker.
3. Press the Sync button on the speaker.