Owner's Manual

CBT 50LA-1 & CBT 100LA-1 Bracket Installation Guide – Page 6
6)
SET THE SWIVEL (PAN) ANGLE
– Loosen the top and bottom bolts on the pivot. Adjust the
side-to-side swivel (ie, pan) aiming angle of the speaker. Tighten the bolts securely.
Maximum Swivel Angles before Wall Interference
– The bracket swivels a full 90 degrees from
side-to-side, however when mounting the CBT speaker onto a wall, the side-to-side swivel is
limited by the end of the speaker encountering the wall. The maximum swivel angle depends on:
a) which of the speaker’s rear-panel positions the
SPEAKER BRACKET
is mounted to, and b) the
down-tilt angle setting.
The following chart lists the typical maximum side-to-side swivel angles for some of the possible
Speaker Bracket mounting point locations, and for 0
°
, 5
°
, 10
°
, and 15
°
down-tilt angle settings.
Model
SPEAKER
BRACKET
Mounting
Position on
Speaker
Maximum Swivel (Pan) Angle at Down-Tilt of:
0º
Down-Tilt
5°
Down-Tilt
10º
Down-Tilt
15º
Down-Tilt
CBT50LA-1
Top Position 80° Swivel 75° Swivel 72° Swivel 66° Swivel
Middle Position 80° Swivel 76° Swivel 75° Swivel 73° Swivel
Bottom Position 80° Swivel 77° Swivel 77° Swivel 75° Swivel
CBT100LA-1
Top-Most
Position * 80° Swivel 69° Swivel 34° Swivel N/A**
Middle Position * 80° Swivel 74° Swivel 67° Swivel 54° Swivel
Bottom-Most
Position * 80° Swivel 77° Swivel 77° Swivel 75° Swivel
* The in-between mounting positions on CBT 100LA-1 have Maximum Swivel Angles in between those listed.
**
The very top bracket position and 15
°
tilt angle interferes with wall even with no swivel angle.
Maximum Swivel Angles in Other Mounting Situations
– The bracket itself can swivel up to 90
degrees (side-to-side), so if the speaker is being mounted onto a pole or an outside corner, for
example, where interference with a wall may not be a factor, then greater swivel angles than those
stated in the above chart may be achieved.
7)
SAFETY CABLE
-- Attach a safety cable (not included) to any of the 6 mm inserts on the back of
the CBT 100LA/50LA-1 cabinet using one of the extra included M6 mm bolts. Attach the other
end of the cable to a secondary attachment point on the wall.
8)
SWITCH COVERS –
To discourage tampering with the switch settings, adhesive switch covers are
provided. Peel off the backing from the switch cover and stick the cover over the switch shaft,
lining up the ridge with the recess in the switch shaft.