Owner's Manual

CBT 50LA-1 & CBT 100LA-1 Bracket Installation Guide – Page 5

SLIDE SPEAKER WITH

SPEAKER BRACKET

ONTO

WALL BRACKET

-- Once the wall mount

has been attached to the wall and speaker mount has been attached to the speaker, slide the

speaker forward so that the

SPEAKER BRACKET

engages into the

WALL BRACKET

, dropping

the hook slot of the

SPEAKER BRACKET

onto the pivot bolt (which will already be installed

loosely in the

WALL BRACKET

SET THE TILT ANGLE

– Once the speaker has nested securely on the pivot bolt, slide the second

M6 34mm bolt into one of the holes in top of the wall bracket to set the angle.

5a) TILT ANGLES

-- The bracket allows for +/-15 degrees of tilt. Some of the extreme tilt angles

are not recommended because the speaker will run into the wall first.

5b) PRE- SET ANGLES

and

CONTINUOUSLY VARIABLE ANGLE

-- The bracket has through

holes for mounting angles of +/- 15 degrees in 5 degree increments. There is also a slot above the

set of holes for continuously variable adjustment. The pre-set angles are recommended for

accurate aiming. Either can be utilized for setting the speaker’s tilt angle.

5c) SECURE THE ANGLE SETTING

-- Once the angle has been chosen, tighten both bolts with

hardware provided.