CBT 50LA-1 & CBT 100LA-1 Bracket Installation Guide Rev B – For Swivel (Pan) / Tilt Wall Bracket Included: SPEAKER BRACKET M6-34L SWIVEL-TILT WALL BRACKET M6-15L M6 nuts SS Lock washers CBT 100LA-1 CBT 50LA-1 SS Flat washers switch covers
CBT 50LA-1 & CBT 100LA-1 Bracket Installation Guide – Page 2 WALL SURFACE MOUNTING Note that the BRACKET ASSEMBLY consists of a SPEAKER BRACKET and a WALL BRACKET. 1) RUN WIRING -- Run the wiring from the power amplifier to the location desired for mounting the JBL CBT Loudspeakers. 2) ATTACH WALL BRACKET TO WALL -- Using a level to ensure that the WALL BRACKET is straight, secure the WALL BRACKET to the wall. Be sure to use the appropriate wall anchors for attaching the bracket.
CBT 50LA-1 & CBT 100LA-1 Bracket Installation Guide – Page 3 3) ATTACH SPEAKER BRACKET TO SPEAKER 3a) CBT 50LA-1 -- Mount the SPEAKER BRACKET to the speaker with the provided M6-15L pan head bolts, lock washers and flat washers, as shown below. For the CBT 50LA-1 there are three (3) possible mounting position. Choose the one that best suits the application. Be sure the hook feature of the SPEAKER BRACKET is downward.
CBT 50LA-1 & CBT 100LA-1 Bracket Installation Guide – Page 4 3b) CBT 100LA-1 -- Mount the SPEAKER BRACKET to the speaker with the provided M6-15L hardware. For the CBT 100LA-1 there are seven (7) possible mounting position. Choose the one that best suits the application. Be sure the hook feature of the SPEAKER BRACKET is downward. Note the bolt attachment configuration for the SPEAKER BRACKET from the diagram on the previous page. 5°5°&&10° down-tilt 10° down-tilt angles Angles OKOK. *. encroaches wall.
CBT 50LA-1 & CBT 100LA-1 Bracket Installation Guide – Page 5 4) SLIDE SPEAKER WITH SPEAKER BRACKET ONTO WALL BRACKET -- Once the wall mount has been attached to the wall and speaker mount has been attached to the speaker, slide the speaker forward so that the SPEAKER BRACKET engages into the WALL BRACKET, dropping the hook slot of the SPEAKER BRACKET onto the pivot bolt (which will already be installed loosely in the WALL BRACKET).
CBT 50LA-1 & CBT 100LA-1 Bracket Installation Guide – Page 6 6) SET THE SWIVEL (PAN) ANGLE – Loosen the top and bottom bolts on the pivot. Adjust the side-to-side swivel (ie, pan) aiming angle of the speaker. Tighten the bolts securely. Maximum Swivel Angles before Wall Interference – The bracket swivels a full 90 degrees from side-to-side, however when mounting the CBT speaker onto a wall, the side-to-side swivel is limited by the end of the speaker encountering the wall.
CBT 50LA-1 & CBT 100LA-1 Bracket Installation Guide – Page 7 CBT 50LA-1 & 100LA-1 Bracket Dimensions JBL Professional 8500 Balboa Blvd.
