JS-120 Speaker Stands Quick Specs

Features

• Designed for the L100 Classic

• Also supports the original L100, L100A, L100 Century,

4312E, 4312SE, 4312G and 4319

• 4 rubber-tipped ﬂoor feet are included

• Packed and sold in pairs

• Metal construction with black ﬁnish

Speciﬁcations

Rear Height (bottom of speaker): 5.65" (143.4mm)

Rear Riser Height: 9.29" (235.9mm)

Rear Height (including riser): 9.29"

Front Height (bottom of speaker): 7.075" (179.7mm)

Tilt-back angle: 7 degrees

NOTE: Feet are adjustable in height

JS-120 Loudspeaker Stand

7°

10.082 in.

(256.1mm)

12.677 in.

(322mm)

14.252 in.

(362mm)

7.126 in.

(181mm)

7.077 in.

(179.8mm)

11.732 in.

(298mm)

3.667 in.

(93.15mm)

11.047 in.

(280.6mm)

9.287 in.

(235.9mm)

PAGE 1
0.082 in. (256.1mm) JS-120 Loudspeaker Stand 12.677 in. (322mm) 11.732 in. (298mm) 14.252 in. (362mm) 11.047 in. (280.6mm) Features • Designed for the L100 Classic • Also supports the original L100, L100A, L100 Century, 4312E, 4312SE, 4312G and 4319 • 4 rubber-tipped floor feet are included • Packed and sold in pairs • Metal construction with black finish Specifications Rear Height (bottom of speaker): 5.65" (143.4mm) Rear Riser Height: 9.29" (235.9mm) Rear Height (including riser): 9.
PAGE 2
JS-120 Loudspeaker Stand JS-120 LOUDSPEAKER STAND ASSEMBLY INSTRUCTIONS Step 1 - Locate the parts (packed with the stand) that contains 4 pieces of rubber feet. Place the stand upside down and install the bottom base with rubber feet as shown below. Tighten the rubber feet in clockwise direction. Step 2 - Place your loudspeaker as shown. HARMAN International Industries, Incorporated 8500 Balboa Boulevard, Northridge, CA 91329 USA www.jblsynthesis.com © 2018 HARMAN International Industries, Incorporated.