Owners Manual

5
English English
Using Bare Wire or Pin Connectors:
A. Unscrew Cap B. Insert Bare Wire
or Pin Connector
through Hole in Post
C. Tighten Cap to
Secure Wire
IMPORTANT: Make sure the (+) and (–) wires or pins do not touch each other or the other terminal. Touching wires can
cause a short circuit that can damage your receiver or amplifier.
NOTE: Bare wire can also be wrapped around the terminal shaft and then the cap tightened to secure the wire.
CAUTION: Once the caps are tightened, make sure that the jumper straps are held firmly between the respective
terminals. If they are loose, the speakers will not operate properly.
Using Spade Connectors:
A. Unscrew Cap B. Insert Spade
Connector Blades
around Post
C. Tighten Cap
IMPORTANT: Make sure the (+) and (–) spade connector blades do not touch each other or the other terminal.
Touching blades can cause a short circuit that can damage your receiver or amplifier.
CAUTION: Once the caps are tightened, make sure that the jumper straps are held firmly between the respective
terminals. If they are loose, the speakers will not operate properly.
Using Banana Connectors:
A. Tighten Cap B. Insert Banana Connector into Hole in Cap
CAUTION: Be sure to tighten the caps to make sure that the jumper straps are held firmly between the respective
terminals. If they are loose, the speakers will not operate properly.