Owner's Manual

When all wires are set into place as shown in #9, tighten
down both gland nuts by rotating the larger side until
the gland material clamps down on the wire creating a
water tight seal.
Line up the upper section pins and lower section
grooves.
Begin to re-assemble speaker by taking care to place wire nut
connectors in top section of speaker and reattach the seal
plate with screws as shown above.
Rotate top section counter-clockwise to lock the
top to the bottom section, being careful to line up
the security screw hole with brass nut on the
bottom half of the speaker.
Using included security screwdriver, and making sure you
have lined up the security screw with brass nut, turn clock-
wise so screw will lock top and bottom section together.
8
9
10
11
12
13
Replace cap covering set screw.