Owner's Manual

Step 4 - Remove the protective liner over the adhesive gasket surrounding the underside of the Panel
Cover. Attach the Panel Cover through the existing screw holes, USING THE
NEW SCREWS
PROVIDED WITH THE PANEL COVER.
It might be necessary, depending on the stiffness of the
cable, to slide the cable through the gland fitting to avoid strain
on the wire or connections inside the
Panel Cover.
Note: The new screws provided with the MTC-PC2 are longer than the screws previously removed
in Step
1. Use the new screws. DO NOT reuse the screws previously removed in Step 1.
\
(MTC-PC2 shown)
Step 5 -Tighten the nut on the gland fitting to seal around the cable to a recommended torque of
80 in! lbs. The fitting is specified to be liquid-tight for round cables and many near-round cables.
If the fitting does not achieve a tight seal on a particular cable type, it might be necessary to use a
different, rounder, cable type
or to reinforce the seal with sealant (in which case the success of the
seal is the responsibility
of the installer).
I
~
(MTC-PC2 shown)
Caution:
The Panel Covers are intended solely to provide protection for the input connections
of the loudspeaker. Do NOT suspend the loudspeaker by the Panel Cover fitting.
Mod el Compatibility - MTC-PC2 and MT C-PC3 fit JBL 's stand ar d 1.7" x 1.7'' (43 x 43 mm) input cup
which includes the following models (at the time
of this writing):
Control23-l, 25-1 , 28-1 , SB2210, 25AV, 29AV, 30, 31 , 1, 5. CBT 70J-l , 70JE-l, 200LA-l, lOOLA-1 ,
50LA-l. Plus older models
Control23 , 23T, 25 , 25T, 28, 28T-60.
The MTC-PC2 & MTC-PC3 do NOT fit the older model Control SB210 which came with the
slightly larger MTC-PC4 cover.
. HARMAN
JBL Professional
8500 Balboa Blvd, P.O.
Bo x 2200
Northridge,
CA 91329 U.S.A.
MTCPC2-3 INSTR
03/2016