Owner's Manual

,,,HARMAN
Using the Remote Control
Source Selection
The Source Selection control on the remote control only functions when
the Source Selector knob for that zone
is set to "REMOTE" on the mixer.
When the remote control
is active, the green LED on the remote control
below the Source switch (labelled ACTIVE) lights. When this LED
is not lit,
the remote source control
is not operational.
Volume Control
The LEVEL on the mixer
is ALWAYS operational, regardless whether the
Source Selector
is active or not. This remote control is ATIENUATE ONLY.
To set the volume control of the remote control, you can follow the steps:
1. Turn the remote control LEVEL to maximum (full clockwise).
2. Set the volume control on the mixer to the loudest you will ever need
the system to be.
3. Turn the remote control LEVEL knob down to a comfortable or typical
operating level. Now the remote control volume control cannot turn
the volume up above what
is set on the mixer.
Compatibility Between CSR Remote Control and CSM
Mixers
Remote Control
CSR-V
CSR-2SV
CSR-3SV
* when using two input sources
4
Mixer
CSM-21
CSM-32
..;
..;
..;
..j*
..;