Instructions

OK
TOOL
EARTHING FUSE
AUX
USE ONLY WITH A 250 V FUSE
A
B
C360-001
C360-003
C360-007
C360-002
C360-004
C360-006
OK
TOOL
EARTHING FUSE
AUX
USE ONLY WITH A 250 V FUSE
A
B
C360-001
C360-003
C360-007
C360-002
C360-004
C360-006
OK
TOOL
EARTHING FUSE
AUX
USE ONLY WITH A 250 V FUSE
A
B
C360-001
C360-003
C360-007
C360-002
C360-004
C360-006
Changing Tips
1. To remove the tip, use a pair of flat-nosed
pliers, twist the tip and pull.
2. To fasten the tip, do not hold it on the spring
clamp. Place the pliers directly in front of the
spring.
Note: This operation should be done while the tip is hot and at a minimum temperature of
250°C, so that any tin left inside is still molten.
Cleaning Tips
Choose the cleaning rod diameter
according to the tip size. Put the rod at
the tip, gently move it back and forth
while turning it slightly.
The tip hole should be periodically cleaned.
Note: Let the tool cool down before performing this operation.
Tips Care
To prevent tip oxidation cover tip with solder tin when not in use. Note: Do not press the vacuum
pump button while tinning the desoldering tip, as the fumes given off by the flux would quickly block
the ducts and the air filter.
www.jbctools.com
7