Instruction Manual

ENGLISH USER MANUAL
JB SYSTEMS
®
4/5 ACCU-LIGHTBAR
11. Eye bolt for safety cable.
12. Magnetic base for easy mounting the projector on steel surfaces. With M10 hole for clamp
13. Slit for Velcro strap
ELECTRICAL INSTALLATION
Important: The electrical installation should be carried out by qualified personal only,
according to the regulations for electrical and mechanical safety in your country.
Note: In the explanations below we assume that you will operate the projectors with the internal battery
which is already fully charged. If you want to use them with a mains cable, simply connect all projectors to
the mains using the supplied power cable and adaptor.
Electrical installation for 1 standalone unit:
• Switch the projector on using the power switch (6). The unit starts working immediately in the last
selected stand-alone mode.
OPERATING INSTRUCTIONS
A. Standalone: Choose the desired light output by pressing the LED dimming button (3).
B. Controlled by IR remote-controller:
1. [OFF]-button: used to switch off the output of the projector.
2. [UP]-button: this button is used to increase the light output of the projector.
3. [DOWN]-button: this button is used to decrease the light output of the projector.
4. [ON]-button: used to switch on the output of the projector.
5. Battery compartment: receives a CR2025 3V-battery (supplied).
MAINTENANCE
• Switch off the unit and unplug the mains cable.
During inspection the following points should be checked:
• When an optical lens is visibly damaged due to cracks or deep scratches, it must be replaced.
• The mains cables must be in impeccable condition and should be replaced immediately when even a
small problem is detected.
• In order to protect the device from overheat the cooling fans (if any) and ventilation openings should be
cleaned monthly.
• BATTERY maintenance: We strongly advice to follow the maintenance requirements imposed by the
battery reseller. On top of that you should at least every 6 months:
• Do a visual check of the battery: cleanness, terminal damage, any damage of the housing, …
• Check if the poles of the battery are still well tightened to the wires.
Attention: We strongly recommend internal cleaning to be carried out by qualified personnel!
RECYCLING OF USED BATTERIES: used Li/ion batteries should be considered and handled as
dangerous waste. Each country has its own regulations for the recycling of used rechargeable
batteries: check the local regulations in your country or ask your battery vendor for more information
on recycling of the used rechargeable batteries!