Instruction Manual

ENGLISH USER MANUAL
JB SYSTEMS
®
3/5 ACCU-LIGHTBAR
• Due to safety reasons it is prohibited to make unauthorized modifications to the unit.
Important: Never look directly into the light source! Don’t use the effect in the presence of persons suffering
from epilepsy.
OVERHEAD RIGGING
• Important: The installation must be carried out by qualified service personal only. Improper
installation can result in serious injuries and/or damage to property. Overhead rigging requires
extensive experience! Working load limits should be respected, certified installation materials
should be used, the installed device should be inspected regularly for safety.
• Make sure the area below the installation place is free from unwanted persons during rigging, de-rigging
and servicing.
• Locate the fixture in a well ventilated spot, far away from any flammable materials and/or liquids. The
fixture must be fixed at least 50cm from surrounding walls.
• The device should be installed out of reach of people and outside areas where persons may walk by or be
seated.
• Before rigging make sure that the installation area can hold a minimum point load of 10times the device’s
weight.
• Always use a certified safety cable that can hold 12 times the weight of the device when installing the unit.
This secondary safety attachment should be installed in a way that no part of the installation can drop
more than 20cm if the main attachment fails.
• The device should be well fixed; a free-swinging mounting is dangerous and may not
be considered!
• Don’t cover any ventilation openings as this may result in overheating.
• The operator has to make sure that the safety-relating and machine-technical
installations are approved by an expert before using them for the first time. The
installations should be inspected every year by a skilled person to be sure that safety
is still optimal.
DESCRIPTION:
1. LED projector (can be turned 180° vertical and 330° horizontal)
2. Removable magnetic filter holder.
3. LED dimming button
4. Power input connector. (15V DC / 1.6A)
5. Charging (red) and charged (green) LED indicators.
6. [ON/OFF] switch : switch it to turn the projector ON or OFF.
7. Battery status LEDs (25 – 50 – 75 or 100% charged)
8. IR sensor
9. Hole (5/8”) on the side to fix the projector on a microphone stand.
10. Hole (3/8”) on the side to fix the projector on a microphone stand.