Instruction Manual

ENGLISH USER MANUAL
JB SYSTEMS
®
4/5 ROTOGOBO OUTDOOR
EXCHANGING A GOBO
The logo projector accepts both metal and glass
gobos.
GOBO SIZE: Ø 37,5mm / IMAGE SIZE: Ø 24,5mm
• Make sure the area is free of dust before opening
the projector.
• Unplug the projector from the mains.
• Use a crosshead screwdriver to remove the 4
screws on the frontside of the projector.
• Carefully remove the front from the projector.
• On the inside you will see the gobo, black protection ring and spring.
• Squeeze spring gently and remove it.
• Gently tilt the projector forward so that the black ring and gobo also fall into your
hand.
• Insert the new gobo in the projector (make sure any text is in mirror image)
• Add the black ring on top of the gobo
• Squeeze the fixation-spring and press it gently against the black ring. (make sure that
there is no play between the parts)
• Check the rubber seal on the front part and remove any dirt on the rubber seal.
• Press the front part again to the projector and make sure that the seal closes the unit
perfectly.
• Close the enclosure again with the 4 screws.
• Done!
MAINTENANCE
• Make sure the area below the installation place is free from unwanted persons during servicing.
• Switch off the unit, unplug the mains cable and wait until the unit has been cooled down.
During inspection the following points should be checked:
• All screws used for installing the device and any of its parts should be tightly fastened and may not be
corroded.
• Housings, fixations and installations spots (ceiling, truss, suspensions) should be totally free from any
deformation.
• When an optical lens is visibly damaged due to cracks or deep scratches, it must be replaced.
• The mains cables must be in impeccable condition and should be replaced immediately when even a
small problem is detected.
• In order to protect the device from overheat the cooling fans (if any) and ventilation openings should be
cleaned monthly.
• The interior of the device should be cleaned annually using a vacuum cleaner or air-jet.
• The cleaning of internal and external optical lenses and/or mirrors must be carried out periodically to
optimize light output. Cleaning frequency depends on the environment in which the fixture operates: damp,
smoky or particularly dirty surroundings can cause greater accumulation of dirt on the unit’s optics.
• Clean with a soft cloth using normal glass cleaning products.
• Always dry the parts carefully.
Attention: We strongly recommend internal cleaning to be carried out by qualified personnel!