Instruction Manual

ENGLISH USER MANUAL
JB SYSTEMS
®
3/5 ROTOGOBO OUTDOOR
DESCRIPTION:
1. FOCUS knob: used to adjust the sharpness of the
projection. Turn in either direction until the projection is
perfectly sharp.
2. PRESSURE VALVES: serves to drain vapor or
condensation. NEVER remove or damage these valves!
3. HANGING BRACKET: used to fix the projector on a flat
surface and point it in the desired direction.
4. POWER SUPPLY: external waterproof power supply to
ensure that the projector works operates on a non-
hazardous 12V low voltage.
5. MAINS INPUT: 100V-240Vac mains input, equipped with a
3-wire power cable and standard “type E” CEE7/5 plug.
Always connect it to a wall socket with earth connection.
6. DC-OUTPUT: the 2-wire cable, fitted with a waterproof
connection box, connects with the projector. If the cable
between the projector and PSU is not long enough, you can
extend it using a waterproof junction box.
7. GOBO ROTATION SWITCH: used to switch manually
between rotating and fixed gobo.
OVERHEAD INSTALLATION
• Important: The installation must be carried out by qualified service personal only. Improper
installation can result in serious injuries and/or damage to property. Overhead installation
requires extensive experience! Working load limits should be respected, certified installation
materials should be used, the installed device should be inspected regularly for safety.
• Make sure the area below the installation place is free from unwanted persons during installation and
servicing.
• The device should be installed out of reach of people and outside areas
where persons may walk by or be seated.
• Before installation make sure that the installation area can hold a minimum
point load of 10times the device’s weight.
• The device should be well fixed; a free-swinging
mounting is dangerous and may not be considered!
• The projector should be attached to the wall or
ceiling using the anchor provided or other
professional installation material:
• Drill a hole Ø10mm in the brick / Concrete wall
• Put the anchor bolt in the hole (cleave part first)
• Install the bracket of the projector as shown on
the picture (threaded rod in the bracket hole)
• Attach and tighten the nut until the projector is
securely attached to the wall.
• Don’t cover the large heatsink on the back of the unit
as this may result in overheating.
• The operator has to make sure that the safety-
relating and machine-technical installations are
approved by an expert before using them for the first
time. The installations should be inspected every
year by a skilled person to be sure that safety is still
optimal.