User Manual

ENGLISH USER MANUAL
JB SYSTEMS
®
5/7 ROTOGOBO ZOOM
• All slave units must be set to [SLAVE MODE]
3) DMX CONTROLLED:
The projector can be controlled by any standard DMX-controller in different DMX-modes.
To do this, you need to set the desired start address and DMX mode for each unit
• Press the [MENU] button until the display shows: [DMX MODE - ADDR: xxx]
• Use the [UP] or [DOWN] buttons to set the DMX address and press [ENTER] to confirm.
• The display shows: [DMX MODE - CHAN: xx] → press [UP/DOWN] to select the Channel mode.
• Press [ENTER] to confirm: press [UP/DOWN] to select the Dimmer speed → LED or Halogen.
• Press [ENTER] to confirm: press [UP/DOWN] to select the desired dimmer curve.
• Press [ENTER] to confirm: the projector is ready to be used in DMX mode.
Some more information on DMX512:
The DMX-protocol is a widely used high speed signal to control intelligent light
equipment. You need to “daisy chain” your DMX controller and all the connected light
effects with a good quality XLR M/F balanced cable. To prevent strange behavior of
the light effects, due to interferences, you must use a 90Ω to 120Ω terminator at the
end of the chain. Never use Y-splitter cables, this simply won’t work!
Each effect in the chain needs to have its proper starting address so it knows which commands from the
controller it has to decode.
[CHAN01] Mode:
DMX Channel
DMX-value
function
1
000-255
Dimmer
Note: rotation on/off, rotation speed and direction of the rotation can be adapted in the setup menu.
[CHAN02] Mode:
DMX Channel
DMX-value
function
1
000-255
Dimmer
2
000-031
Led OFF
032-063
Led ON
064-095
Strobe (slow to fast)
096-127
Led ON
128-159
Pulse effect (slow to fast)
160-191
Led ON
192-223
Random Strobe (slow to fast)
224-255
Led ON
Note: rotation on/off, rotation speed and direction of the rotation can be adapted in the setup menu.