User Manual

ENGLISH USER MANUAL
JB SYSTEMS
®
3/7 ROTOGOBO ZOOM
OVERHEAD RIGGING
• Important: The installation must be carried out by qualified service personal only. Improper
installation can result in serious injuries and/or damage to property. Overhead rigging requires
extensive experience! Working load limits should be respected, certified installation materials
should be used, the installed device should be inspected regularly for safety.
• Make sure the area below the installation place is free from unwanted persons during rigging, de-rigging
and servicing.
• The device should be installed out of reach of people and outside areas where persons
may walk by or be seated.
• Before rigging make sure that the installation area can hold a minimum point load of
10times the device’s weight.
• Always use a certified safety cable that can hold 12times the weight of the device when
installing the unit. This secondary safety attachment should be installed in a way that no
part of the installation can drop more than 20cm if the main attachment fails.
• The device should be well fixed; a free-swinging mounting is dangerous and may not be considered!
• Don’t cover any ventilation openings as this may result in overheating.
• The operator has to make sure that the safety-relating and machine-technical installations are approved by
an expert before using them for the first time. The installations should be inspected every year by a skilled
person to be sure that safety is still optimal.
DESCRIPTION:
1. MAINS INPUT: equipped with PowerCON
®
compatible connectors. Connect the supplied mains cable or
any PowerCON
®
extension cable here.
2. MAINS OUTPUT: used to daisy chain the power to several other projectors. Always pay attention to the
maximum load while adding projectors! Special Multi cables (PowerCON
®
+ DMX XLR-cables are
optionally available)
3. Safety eye: here you can attach an optional safety cable when you are rigging the ROTOGOBO ZOOM
in a light bridge.
4. DMX INPUT: 3pin male XLR-connector used to connect the projector with
the DMX controller or with the previous unit in the DMX chain.
5. DMX OUTPUT: 3pin female XLR-connector used to connect the projector
with the next unit in the DMX chain.
6. M-DMX INPUT: Please note that this USB-connector is NOT used for
updates or to connect the unit to a PC! Instead, this USB-connector makes
it very easy to add wireless DMX to the unit! Just add the (optional) WTR-
DMX DONGLE from BRITEQ
®
and you will get wireless DMX! Moreover,
you will be able to connect other DMX-controlled equipment to the DMX-
output so you can share the wireless DMX function with all connected
units! No extra settings to be made in the setup menu, just follow the
procedure in the user manual supplied with the WTR-DMX DONGLE from
BRITEQ
®
. The separate WTR-DMX DONGLE is available from
WWW.BRITEQ-LIGHTING.COM (order code: 4645).
7. MAINS FUSE: protects the unit in case of electrical problems, always use
the prescribed fuse!
8. MODE button: used to browse the different functions in the menu.
9. ENTER button: used to confirm your choice or to enter the setup mode of
a function.
10. UP button: to increase the values shown on the display.
11. DOWN button: to lower the values shown on the display.
12. DISPLAY shows the various menus and the selected functions.
13. GOBO LOCK: Used to lock/keep the gobo holder in place.
14. GOBO HOLDER: used to install the gobo in the projector.
15. FOCUS knob: used to adjust the sharpness of the projection.
16. ZOOM knob: used to make the projection smaller/bigger. Each time the
projection size is changed, the focus should also be adjusted.
17. FILTER FRAME lock: At the front, you can insert an optional color filter
into the filter frame. The locking mechanism keeps the filter frame in place.