ENGLISH USER MANUAL OPERATION MANUAL Thank you for buying this JB SYSTEMS® product. To take full advantage of all possibilities and for your own safety, please read these operating instructions very carefully before you start using this unit.
ENGLISH USER MANUAL SAFETY INSTRUCTIONS: CAUTION: To reduce the risk of electric shock, do not remove the top cover. No user-serviceable parts inside. Refer servicing to qualified service personnel only. The lightning flash with arrowhead symbol within the equilateral triangle is intended to alert the use or the presence of un-insulated “dangerous voltage” within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock.
ENGLISH USER MANUAL OVERHEAD RIGGING • Important: The installation must be carried out by qualified service personal only. Improper installation can result in serious injuries and/or damage to property. Overhead rigging requires extensive experience! Working load limits should be respected, certified installation materials should be used, the installed device should be inspected regularly for safety.
ENGLISH USER MANUAL SETUP MENU Explanation of all setup menu functions. MAIN MENU SUB MENU VALUES MODE-button ENTER-button UP/DOWN buttons ADDR 001 - 512 CHAN 01 - 02 - 03 - 04 HALOGEN DimSpeed LED DMX MODE Linear Square DimCurve I. Square S-Curve SLAVE MODE 000 - 100 DIMMER STROBE SPEED 00 - 15 ON /OFF ROTATION SPEED 01 - 05 DIRECTION LEFT / RIGHT FADE RUN SPEED 01 - 16 DISP ON /OFF IR ON /OFF OPTION WDMX ON /OFF RESET UP+DOWN Remarks → Buttons to press to use the setup menu.
ENGLISH USER MANUAL • All slave units must be set to [SLAVE MODE] 3) DMX CONTROLLED: The projector can be controlled by any standard DMX-controller in different DMX-modes. To do this, you need to set the desired start address and DMX mode for each unit • Press the [MENU] button until the display shows: [DMX MODE - ADDR: xxx] • Use the [UP] or [DOWN] buttons to set the DMX address and press [ENTER] to confirm. • The display shows: [DMX MODE - CHAN: xx] → press [UP/DOWN] to select the Channel mode.
ENGLISH USER MANUAL [CHAN03] Mode: DMX Channel 1 2 3 DMX-value 000-255 000-005 006-186 187-189 190-219 220-222 223-253 254-255 000-005 006-249 250-255 function Dimmer No Rotation Gobo indexation No Rotation Left Rotation (fast to slow) No Rotation Right Rotation (slow to fast) No Rotation GOBO Indexing disabled GOBO Indexing enabled GOBO Indexing disabled DMX-value 000-255 000-031 032-063 064-095 096-127 128-159 160-191 192-223 224-255 000-005 006-186 187-189 190-219 220-222 223-253 254-255 000-005 0
ENGLISH USER MANUAL MAINTENANCE • Make sure the area below the installation place is free from unwanted persons during servicing. • Switch off the unit, unplug the mains cable and wait until the unit has been cooled down. During inspection the following points should be checked: • All screws used for installing the device and any of its parts should be tightly fastened and may not be corroded.
