Use and Care Manual

www.longer3d.com [e-mail]
16
C. Machine Operation
(1) Focusing the Laser Module
a) Place the machine on a flat table and make sure that the
machine is stable and will not shake.
b) Place the wood board to be engraved or cut under the laser.
c) Loosen the two thumb screws on the front of laser head by
hand. Then place the focus plate vertically on the bottom of
the laser head form the rear side, and manually lift the laser
head so that the bottom of the rear side of the laser is close
to the upper surface of the focus plate.
d) Tighten the two thumb screws, and then remove the focus
plate.