FRAMESET SERIES Owner’s Manual Serial No: All Rights Reserved. Rev 1.
ATTENTION! Important safety instructions. Please read these instructions thoroughly before using this product. IMPORTANT SAFETY INSTRUCTIONS CONTENTS Safety & Warranty Warning....................01 Parts List ............................................02 Installation Guide................................03 Remote Control Guide........................10 APP Control Guide..............................11 Troubleshooting..................................
Optional Accessories (stabilizer bracket) Standard Parts List All electronics and components that need to be installed are placed in boxes under the foundation or attached to the frame. Before discarding the packing materials, ensure that all the parts are accounted for. x1 x1 x1 x6 x1 x4 x4 L-Plate 3"+6" Wireless Remote Power Supply （29V 2.
2. 5. 2 Slide the left side of the mattress retainer bar into the block. Pull the retainer bar to the opposite bracket and secure the right side. 1 Remove the foundation from the box. Make sure the floor is clean. Flat the foundation. 3. 6. Connect the DC power cord to the power supply, uncoil the AC power cord and then connect it to the AC power source . DC Power Cord AC Power Source AC Power Cord Power Supply Connect the connectors as illustrated. Install legs and tighten by hand. 4.
Installation Guide (headboard bracket) 1. x1 x2 x4 x1 Headboard Brackets Mount 2. Washer (d8.5D17t1.2) T-channel Assy x2 Hex Head Bolt (M8×20) M8 Lock Nuts Assemble the zero clearance accessories as the picture shows. Install headboard brackets with socket screw wrench and simple open end wrench. 2. Installation Guide (stabilizer bracket) 1. Install the assembled headboard brackets with washer(d10D30t2) and hex socket button head screws(M10×25) onto the end of head frame. fig.
Add Additional Leg Supports For Slat/Platform Foundation. Synchronizing Two Foundations Support legs may be needed on some slat/platform foundation, refer to the leg configuration table for height adjustment. If simultaneous operation of two foundations is desired, use the sync cord to connect the electronics of both foundations together.
Battery Lock Wire Installation Guide（Optional Accessories） Remote Control Guide When disconnect the power supply,the battery lock wire and two batteries with 9V 2A can be used together to flat the foundation. 1. Foot lifting LED 9V USB Flat 9V Power Head lifting DC power cord 2. 9V 9V Zero Gravity Head Motor Head lowering Foot Motor APP Sync Foot lowering Dream Motion APP（Optional） The Dream Motion APP is applied to control the foundation, available to both IOS and Android users.
Connect bed Bed List Bed 1 Scan QR code to connect with your bed Alarm Bed 2 Press " Bed 3 Number of motors Massage Under-bed lighting 2 8 HR 0 MIN of sleep in total Bed 4 Wake Bedtime 23:00 No No 07:00 Wake-up position Repeat Scan QR code Search Back Device pairing Search to find your device. Backward Flashlight Bedtime reminder Scan to find your device. Choose the part you want to adjust. Press and hold to your desired position. to set wake-up time.
Troubleshooting In the event the adjustable foundation fails to operate, investigate the symptoms and possible solutions below. The adjustable foundation does not respond when the remote is used. Remote control led illuminates and appears to be normal. • Make sure the remote control is paired with the foundation • Check that the power cord is plugged into a working and grounded electrical outlet. Unplug the power cord from the outlet. After 30 seconds, plug it back in.
