FRAMESET M SERIES Owner’s Manual Serial No: All Rights Reserved. Rev 1.
ATTENTION! Important safety instructions. Please read these instructions thoroughly before using this product. IMPORTANT SAFETY INSTRUCTIONS CONTENTS Safety & Warranty Warning....................01 Parts List ............................................02 Installation Guide................................03 Remote Control Guide........................10 APP Control Guide..............................12 Troubleshooting..................................
Optional Accessories (stabilizer bracket) Standard Parts List All electronics and components that need to be installed are placed in boxes under the foundation or attached to the frame. Before discarding the packing materials, ensure that all the parts are accounted for. x1 x1 x1 x6 x1 x4 x4 L-Plate 9V 3"+6" Wireless Remote Power Supply （29V 2.
2. 5. 2 Slide the left side of the mattress retainer bar into the block. Pull the retainer bar to the opposite bracket and secure the right side. 1 Remove the foundation from the box. Make sure the floor is clean. Flat the foundation. 3. 6. Connect the DC power cord to the power supply, uncoil the AC power cord and then connect it to the AC power source . DC Power Cord AC Power Source AC Power Cord Power Supply Connect the connectors as illustrated. Install legs and tighten by hand. 4.
Installation Guide (headboard bracket) 1. x1 x2 x4 x1 Headboard Brackets Mount 2. Washer (d8.5D17t1.2) T-channel Assy x2 Hex Head Bolt (M8×20) M8 Lock Nuts Assemble the zero clearance accessories as the picture shows. Install headboard brackets with socket screw wrench and simple open end wrench. 2. Installation Guide (stabilizer bracket) 1. Install the assembled headboard brackets with washer(d10D30t2) and hex socket button head screws(M10×25) onto the end of head frame. fig.
Synchronizing Two Foundations Electronics Quick Reference Guide If simultaneous operation of two foundations is desired, use the sync cord to connect the electronics of both foundations together. (single bed only) Power LED USB Power USB Charger LED USB Under-Bed Lighting Head Motor Y-cable Wireless Remote DC Power Cord USB LED Foot Motor APP APP Head Motor Sync Foot Motor APP Sync Triplex Cable Quadded Cable Sync Cord STEP 1：Unplug foundations from the power source.
Adjustment Remote Control Guide Stop Massage Head Massage Foot Massage HEAD UP/DOWN BUTTONS Press and hold to lift or lower the HEAD section. FOOT UP/DOWN BUTTONS Press and hold to lift or lower the FOOT section. One Touch Button Press to adjust the foundation to "Memory 1" or "Memory 2". Head Lifting Memory 1 Foot Lifting Flat Memory 2 Head Lowering Under-bed Lighting Foot Lowering STEP 1: Press and hold to your desired position.
Battery Lock Wire Installation Guide Troubleshooting When disconnect the power supply,the battery lock wire and two batteries with 9V 2A can be used together to flat the foundation. 2. LED USB 9V Power 1. DC power cord 9V 9V In the event the adjustable foundation fails to operate, investigate the symptoms and possible solutions below. The adjustable foundation does not respond when the remote is used. Remote control led illuminates and appears to be normal.
